Tableau Ordres De Commande Du Système; Tableau Codes Des Erreurs - Baumer UNCK 09G8914/IO Mode D'emploi

Teach-in lock 0X61
6.3 Tableau Ordres de commande du système
Restore factory setting 0X02
Teach-in 0X02
switching point A
Teach-in 0X02
switching point B
Transfer 0X02
switching points
Teach-in measuring 0X02
range limit A
Teach-in measuring 0X02
range limit B
Transfer 0X02
measuring range
6.4

Tableau Codes des erreurs

Communication error
(Checksum, ...)
Length of written SPDU is wrong
Reading an unimplemented SPDU
Writing to an unimplemented SPDU
Reading Index 2
Writing to a read only SPDU
Writing an unimplemented System Command
Written parameter out of defined range
fr_BA_UNXK 09-IO-Link.doc
24.04.2012/haa
1 -
0X82 Restores all original factory settings of the sensor
0XA0 Teach-in of switching point A. The measured distance is written into the interim switching
points register.
0XA1 Teach-in of switching point B. The measured distance is written into the interim switching
points register.
0XA2 Transfer of the switching points from the interim register to the working register.
0XA3 Teach-in of measuring range limit A. The measured distance is written into the measuring
range interim register
0XA4 Teach-in of measuring range limit B. The measured distance is written into the measuring
range interim register.
0XA5 Transfer of the measuring range from the interim register to the working register
0x10 0x00
0x10 0x00
0x80 0x11
0x80 0x11
0x80 0x23
0x80 0x23
0x80 0x23
0x80 0x30
0,1,2 R/W Teach-in button lock/unlock respectively
0 = Teach-in button always locked.
1 = Teach-in button always unlocked.
2 = Teach-in button locked 5 min after
Power-On.
Communication error, No details
Communication error, No details
Device error, Index not available
Device error, Index not available
Device error, Access denied
Device error, Access denied
Device error, Access denied
Device error, Parameter value out of range
16/18 Baumer Electric AG
Frauenfeld, Switzerland