Perel Tools LEDA3001xx-xP Mode D'emploi page 7

LEDA3001xx-xP/3002xx-xP/3003xx-xP/3005xx-xP
Warning: if the power cable is damaged, it must be replaced by the
manufacturer, his service agent, or a similar qualified person in order
to avoid any hazard.
5. To point the lamp in the desired direction: loosen the hinges [2]
using a spanner.
6. Tilt the lamp in the desired angle and tighten the hinges.
7. Sensor controls
The sensor controls on the bottom of the PIR sensor are:
 LUX: The device can distinguish between day and night thanks to
the adjustable ambient light setting. The device can work in the
daytime when the "sun" (max.) position is selected with the
selector at the back of the device. When set to "moon", the sensor
remains inactive during daylight. To set the sensitivity level, wait
until it gets darker and set the sensitivity you want.
 TIME: Use the time adjustment control to set how long the
floodlight will stay on after the motion has been detected
(5 seconds to 11 minutes).
 SENS: Use the detection distance control to increase or decrease
the sensor's detecting distance (approximately 12 to 15 meters).
8. Cleaning and maintenance
 All screws should be tight and free of corrosion.
 The housing, the visible parts, the mounting supports and the
installation location (e.g. ceiling, suspension, trussing) should not
be deformed, modified or tampered with; e.g. do not drill extra
V. 03 – 16/02/2016
N = neutral, blue
E = earth, yellow/green
L = line, brown
7 ©Velleman nv