Operating Instructions
1
2
3
SHELVES
Two metal wire shelves are included with the unit that can be removed and adjusted to different levels
to accomodate different growing heights. Please use caution when removing a shelf as it may be un-
balanced, heavy or contain residual water. Do not remove shelving without fi rst removing everything
on the shelf.
SHELVES - DGA19
•
Make sure the shelf is aligned with the lock block when taking the shelf out or
putting it back into the unit.
•
To remove a rack from its locked position, tilt the rack as shown and pull out-
ward.
•
To re-install, ensure the rack is resting securely on the support brackets and
push the rack inward until it locks into place.
SHELVES - DGA24
To remove shelves:
•
Fully extend the shelf you wish to remove.
•
Lift the front of the shelf up.
•
Holding the shelf track, push the shelf in, then up to release from the
rear dampers.
FEATURES
1. Tempered glass door: Used to refl ect heat.
4
2. Magnetic door gasket: Tight fi tting seals to ensure a
good seal with the cabinet.
3. Handle
4. Mars Hydro® Light system: Not pictured. Can be set to
Growth or Bloom light cycles.
5
5. Shelves: Two metal wire shelves.
6. Leveling Legs
7. Fan: Not pictured.
Note: Door swing cannot be reversed.
Note: Your appliance may look slightly different based on the
cabinet that was used to build the Danby Fresh Grower.
Note: Two plastic trays are included with the unit. Place plant
pots on these trays to ensure that if water leaks from the plant
6
pots it will not leak from the unit and damage your fl oors.
3