General Information - Doro rp2001x Manuel D'utilisation

English

General information

This DECT repeater is compatible with most GAP (Generic Access Profile) DECT
cordless telephones irrespective of manufacturer, however, the GAP protocol does not
guarantee that all units or functions will work. Certain DECT cordless telephones have
a menu selection for repeater operation (repeater enabled base units only) please refer
to the manual or with the manufacturer of the telephone you intend to use with this
repeater.
Up to five repeaters may be used with one DECT cordless telephone with each repeater
being capable of handling two handsets simultaneously.
Communication takes place according to the GAP protocol and does not guarantee
that all functions work when you are connected via the repeater. Functions which do
not always work include, for example, internal calls, caller identification and the ring
signal following the incoming ring signal.
Connection
The repeater must be registered to an operating GAP compatible DECT base unit.
Registering a repeater is similar to registering an additional handset, please refer to your
telephones instruction manual for registration mode programming.
Please ensure that while registering the repeater no other base unit close by is in
registration mode. If you accidentally register the repeater to another/unknown base
unit repeat the registration procedure again
Registration
1. Connect the mains adapter to the repeater and to an electrical wall socket. Ensure
the D.C. connector is correctly inserted in the repeater, the socket has a rubber seal
that creates a tight fit when inserting.
2. Set the required base unit to registration mode.
3. Press and hold the repeater button for 3 seconds until the indicator light starts pulse
flashing.
4. If registration is successful, the repeater will return to standby mode with the
indicator light flashing slowly.
5. To check the repeater is correctly registered unplug the telephone base unit power
supply and check the repeater indicator light. The indicator light should flash
rapidly after a few seconds, if it continues to flash slowly the repeater is registered
to another base unit and the registration process should be repeated ensuring the
correct base unit is set to registration mode.
6. Repeat this procedure if you need to register more than one repeater.
2
All manuals and user guides at all-guides.com
Installation
www.doro.com