Alecto BL-319 Mode D'emploi page 20

All manuals and user guides at all-guides.com
Possible problems and solutions:
First always check whether the power adapter is plugged
in a 230 AC wall socket or the 12 V DC plug is connected
with the cigar-lighter in your car.
Problem:
The red LED on the
power adapter does
not light.
The "discharge/
charge" LED does not
light in the charge-
mode.
Possible cause:
No power on the
wall-socket.
Bad electrical
contact.
The batteries are
installed incorrectly.
The switch is not
set in the correct
position.
When charging only
2 batteries, these are
not installed in the 2
left banks.
Only one battery is
installed.
Only three batteries
are installed and
the switch is set to 4
batteries.
20
Solution:
Check the mains power
by connecting another
device with the wall
socket.
Clean the chargers'
contacts as well as the
contacts of the batteries.
Re-install the batteries
in the correct way.
The switch should be
set in the left position (2
batteries) or in the right
position (4 batteries).
Re-install the 2 batteries
into the 2 most left
banks.
Install a second
battery (same type and
capacity).
Install a 4th battery or
remove one battery.
Check the switch
position (2 or 4
batteries).