Intended Use; Delivery Content - BASETech T-HLP 1800 W Notice D'emploi

3. Intended use

This hot air tool is intended for all applications with hot air that are listed in these operating instruction.
• Removing paint and paint residues
Heat up paint or residual paint on the surface to be treated using the hot air gun and remove using a suitable tool.
• Dissolving adhesives
Many adhesives can be softened using heat. Joints can be separated or excess glue can be removed in this way.
• Soft soldering
The product is suitable for spot soldering or soldering pipes. The fusing temperature of the solder must be below
400 °C.
• Bonding and deforming synthetic materials
Heat up synthetic materials by consistent see-saw movements. Use suitable hot adhesives for bonding.
• Drying
The product can be used for drying coats of paints, binders and sealants.
• Shrinking
Select the shrink hose according to the workpiece and heat up evenly using the hot air gun.
• Thawing of water pipes
Always heat up the frozen section from edge to middle. Exercise extreme caution when heating up plastic pipes and
joints between pipe sections in order to prevent damage.

4. Delivery content

• Heat gun: 1pc
• Instruction manual: 1pc
After unpacking, check the tool and accessories for damages and do not use the tool in case something is defective.
Up-to-date Operating Instructions
Download the latest operating instructions at www.conrad.com/downloads or scan the QR code
shown. Follow the instructions on the website.
All manuals and user guides at all-guides.com
15