Wall Mounting - Grundig GDSP 2460 BC Manuel

INSTALLATION OF APPLIANCE _______________________

Wall Mounting

• Wall must be flat, straight and have the
sufficient bearing capacity.
• Depth of drilling holes must comply with
the length of bolts.
• The bolts and dowels provided are
suitable for brick walls. For other con-
struction material (e.g. drywall, plate,
porous concrete), suitable fixing dowels
and nuts shall be used.
(Figure 7)
CAUTION
Before drilling, ensure that
there are no power, gas or
A
water pipes in the close
proximity of the drilling
locations.
Draw a mid location line from the ceiling
perpendicular to the lower edge of the
hood ().
Paste the installing template provided
within the accessories on the surface
where the hood is to be mounted. In do-
ing this operation, observe the mounting
height of the hood (Page 12 / Figure 6).
There is a tab in the middle of the Chim-
ney connection plate. Place the middle
point of this tab on the line that is drawn
perpendicular to the wall. In doing this op-
eration, adjust the hood according to the
12 ENGLISH
maximum height (Page 8 / Figure 1). Mark
the holes where the Chimney connection
plate will be mounted with the help of a
pen (Figure 7/a).
Drill the marked points with Ø6mm drill
and insert 2 plastic dowels in the drilled
holes (Figure 7/a). Fix the Chimney con-
nection plate to the wall with 3,9x22
screws (Figure 7/a).
To assemble the hood body, you can use
the Ø8mm drill bit to drill points A, B, C,
D on the assembly template, and insert
4.8x50mm plastic dowels at these points.
(Figure 7/b).
2 piece 4.8x50 suspension screw with
a clearance of 5 mm between the screw
head and the wall (Figure 7/b).
(Figure 8)
1. Hanger Plate
2. Hanging Plate Connection Screw
In order to install your hood to the wall,
loosen the screws on the hanger plates
mounted on the motor cabin and pull them
up, and then fasten again (Figure 8 / A).
Turn on the suction glass of the hood and
remove the Aluminum aluminium grease
filter (Page 11 / Figure 4).