What To Do If - IKA VINSTGIVANDE Manuel

10

What to do if ...

Problem
The appliance does not
work
The hood's suction level
is not enough
The light does not work
Before contacting the
Authorized Service Centre
Switch the appliance on again to see
if the problem has disappeared. If
not, switch it off again and repeat
the operation after an hour.
If your appliance still does not
•
work properly after carrying out the
checks listed in the troubleshooting
guide and switching the appliance
on again, contact the Authorized
Service Centre, clearly explaining
the problem and specifying:
Possible cause
There is no mains
electrical power
The appliance is not
connected to the
electrical supply
The suction speed is too
low
The grease filters are
dirty
The air vents are
obstructed
The LED is broken
•
•
•
Solution
Check for the presence of
mains electrical power.
Turn off the appliance and
restart it to see if the faults
persists.
Check if the appliance is con-
nected to the electrical supply.
Turn off the appliance and
restart it to see if the faults
persists.
Check the suction speed and
adjust as necessary.
Check that the filters are clean
If not, clean the filters in the
dishwasher.
Check the air vents for any
obstructions and remove as
necessary.
For replacement, contact the
Authorized Service Centre.
the type of fault;
the model;
the type and serial number of
the appliance (given on the
rating plate)
ENGLISH