clage M 37-O Serie Instructions D'utilisation Et D'installation page 27

Installation
Abb. 6: "Installation with SMB tap"
2. Push the collar on to the ½" water connection of the tap.
3. Screw the tap on to the ½" water connection and seal with thread seal tape. The water
connections must be horizontal.
4. Insert seals into the ⅜" connections of the tap.
5. Hook the instantaneous water heater into the metal wall bracket from above and position it
on the ⅜" connections of the tap.
6. Tighten the union nuts alternately until they are hand-tight. Use a spanner to hold the
instantaneous water heater water connections steady as you do so.
7. Insert the swivel outlet into the tap body from below and screw tight.
8. After installation, check that all connections are tight.
5
4
3
2
7
27
EN