Hartan Racer GT Instructions page 11

Masquer les pouces Voir aussi pour Racer GT:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 14
Instructions
Climatic zone 18
You may open the hood flap to prevent heat from accumulating.
To do so, pull the top cover up. You can fold out the sun shade 21 for
additional protection.
WARNING!
Safety harness
Secure your child with the 5-point belt system 14.
Make sure that the shoulder belts D are inserted and the belt fits snugly
against your child. You can adjust the length and tautness of the belts
with the belt ends F. You can adjust the width of the shoulder and lap
belts by tilting open the quick-release slider G and pulling on the belt E.
Opening the belt: Press the two buttons B at the same time and remove
the magnetic closer A. The bottom fixing C can then be removed easily.
Closing the belt: Hold together the two fixings C and attach the
magnetic closer A; the fastener locks automatically.
Canopy attachment 22
Insert then the fixing peg of the canopy in the slot of the
canopy attachment.
Adjusting the footrest
By pressing the two red safety buttons 15 at the same time, the footrest
can be lowered. When lifting it, adjustment of positions is effected
automatically. The footrest can be lengthened. To do this, pull the two
red pins 16 and turn the footrest by 180°.
WARNING!
In case the carrycot is attached to the frame, the
footrest should always be in horizontal position, as an additional
protection preventing it from slipping out. Secure the carrycot according
to the operating instructions.
Automatic attachment locking
Place the seat unit on the frame in such a way that both locking handles
are sitting on top of the support studs. The latches on both sides lock
automatically as soon as you let go of the handles.
WARNING!
Check before use that the seat unit is securely
fixed! To open the lock, pull the red knob out slightly, then the seat
unit can be removed. The seat unit can also be turned round.
Adjusting the backrest
By raising adjustment lever 13 on the back, the seat­back can be
precisely adjusted to any incline between an upright seated position and
a lying position.
WARNING!
When adjusting the backrest, take care that no movable
parts jam the baby's limbs, or fingers, etc. Finally, make sure the backrest
has reengaged properly.
Protection from falling out
WARNING!
As additional protection against falling out, fix the press­buttons 17 of
the hood to the metal frame of the backrest.
10
14
22
16
17
15
13
17

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Racer gtsRacer r1 gts

Table des Matières