Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
INSTALLATION
Levelling the washer dryer
Warning!
！
The lock nuts on all four feet must be screwed tightly against the housing.
Check if the legs are closely attached to the cabinet. If not, please turn
1.
them to their original positions tighten the nuts.
Loosen the lock nut turn the feet until it closely contacts with the floor.
2.
Adjust the legs and lock them with a spanner, make sure the machine is
3.
steady.
Connect Water Supply Hose
Warning!
！
To prevent leakage or water damage, follow the instructions in this chapter
Do not kink, crush, modify or sever water inlet hose.
For the model equips hot valve,connect it to hot water tap with hot water
supply hose. Energy consumption will decrease automatically for some
program.
Connect the inlet pipe as indicated, there are two ways to connect the inlet pipe.
1. Connection between ordinary tap and inlet hose.
clamp nut
Loosen clamp nut
and four bolts
2.Connection between screw tap and inlet hose.
Tap with threads and inlet hose
1
Raise
1
Tighten clamp
nut
2
Lower
2
slide bushing
Press slide
bushing, insert
inlet hose into
connecting base
Special tap for washer
3
Lock nut
foot
3
Connection
finished
slide bushing
4
4
V.2
Publicité
Table des Matières
