Jacob Jensen Clock II Silver Version Manuel D'utilisation page 28

Back .view
1. Battery compartment
2. TIME SET: Time setting
. SEARCH: search for the remote sensor (not included)
4. RESET: Reset the unit to the default settings
5. DISPLAY LOCK (ON / OFF): Select / deselect the display screen
(bar chart / digits) as default
Activating .the .clock
1. Remove the battery compartment lid.
2. Insert the batteries, matching the poles (+/-), see Fig. 2. On initial set-up,
simply remove the plastic strip in the battery compartment.
. Press RESET after each battery change.
iMpORTAnT: .If the clock is to be connected to a sensor, the sensor must be
activated before the clock. Please see "TO .sET .up .THE .CLOCK .WiTH .A .sEnsOR .
(optional)", .page 29.
28
dispLAY .
The bar chart is the default display.
The display gives a clear picture of the
hour / minutes at a glance.
To .view .the .digit .display .temporarily
Press the centre button CLOCK to
transform the bars into actual digits
and to activate the backlight.
Press again to extend the display period.
To .view .the .digit .display .continuously
1. Press the centre button CLOCK.
2. When the digits are displayed,
slide the button DISP LOCK to ON
(in the battery compartment)
To .view .the .alarm .time
– press CLOCK – .press ALARM less than
two seconds.
Manual .setting .of .the .time and date
Next to the battery compartment on
the back of the alarm clock you will
find the button TIME SET.
1. Press the centre button CLOCK to
view the digit display.
2. Press the TIME SET button for more
than two seconds. The first segment
will start flashing.
12hr .scale
0:00 2:00
1 group (5 dots) = 1 hour Example - time: 03:25
1 group (5 dots) = 5 minutes