Publicité
Les langues disponibles
Les langues disponibles
CG 4032
8. Note: you can take out the jug, pour and serve at any time. The appliance will stop dripping
automatically. But the time cannot exceed 30 seconds.
9. Remove out the jug to serve when finish brewing (about one minute later after the coffee stops
dripping out.)
Note: the coffee you get will be less than the water you have added, as some water is absorbed by
coffee.
Caution: When pour coffee, the momentary incline angle of the jug should not exceed 45
should pour the coffee slowly until the jug is empty, otherwise the coffee in the jug will rush to the
jug lid, and the coffee will flow out from two edges of the lid and will cause scalds.
10.
When the process is finished, if you do not want to serve immediately do not unplug the
power without pulsing the switch. The coffee can be kept warm during 30 minutes and then the
device will stop. For an optimum coffee taste, serve it just after brewing.
11.
Always turn the coffee maker off and unplug the power cord from the electrical outlet when
the coffee maker is not in use.
CLEANING AND MAINTENANCE
CAUTION: Be sure to unplug this appliance before cleaning. To protect against electrical shock, do
not immerse cord, plug or unit in water or liquid. After each use, always make sure plug is first
removed from wall outlet.
1) Clean all detachable parts after each use in hot and sudsy water.
Note: the funnel can be removed from the column to cleaning. When assembling, only insert
the column of funnel into the groove of the appliance.
2) Wipe the product's exterior surface with a soft, damp cloth to remove stains.
3) Water droplets may buildup in the area above the funnel and drip onto the product base
during brewing. To control the dripping, wipe off the area with a clean, dry cloth after each
use of the product.
4) Replace all parts and keep it for next use.
REMOVING MINERAL DEPOSITS
To keep your coffee maker operating efficiently, you should clean away the mineral deposits left by
the water regularly according to the water quality in your area and the frequency use the appliance.
Follow the next instructions:
1. Fill the tank with water and descaler to the MAX level in the gauge of coffee maker (the scale of
water and descaler is 4:1). Please take into consideration the descaler's instructions. Please use
"household descaler". You can also use citric acid instead of the descaler (the one hundred parts of
water and three parts of citric acid).
2. Push the jug on the base. Pay attention to let center line of jug aligns with that of brew basket.
3. Pulse the switch and the indicator of it will be illuminated. After a while, water will drop out
automatically.
4. After percolate the equivalent of one cup and pulse the switch to turn off the appliance.
5. Leave the solution work for 15 minutes, and then repeat the steps of 3-5 again.
6. Turn the appliance on and run off the water until the water tank is completely empty.
7. Rinse by operating the appliance with water at least 3 times.
°
. You
11
Publicité
