Texas Andreas Petersen MINI TEX 200 Manuel D'utilisation page 9

Table of contents
Safety regulations
Assembly instructions
Before starting motor
Driving technique and tips
Adjustment and maintenance
Storage
Technical specifications
Declaration of conformity
Accessories
Important
Sparepart list www.texas.dk
Congratulations on purchasing your new rotary cultivator. While we are certain it will fully live up to your
expectations, to get the most out of your new garden tool you should carefully read the instructions first, especially
the safety regulations, which are marked with the following symbol:
Safety regulations
When using the cultivator, the following safety instructions should be carefully followed. Always be sure that you can
stop the machine at once and switch the motor off in case of accident. All instructions for safety and maintenance
are for your own benefit.
Never use the cultivator for work other than that described in the manual.
Use only original accessories and spares. Fitting unauthorised parts can be dangerous and is therefore
illegal. The manufacturer disclaims all liability in the case of accident or other damage caused by the
fitting of unoriginal parts.
Before using the machine, you should let the dealer or other expert show you how to operate it.
The person operating the machine is responsible for the safety of others in the vicinity. Never use
the machine when others, especially children or animals, are nearby.
The machine should not be used by minors.
The machine should only be lent to persons who know how to use it. For good measure, always
make sure they have the manual as well.
The cultivator should only be used by fit, healthy persons. If you get tired, take frequent breaks.
Never use the machine after drinking alcohol.
The factory-fitted control units, such as the gas cable from the handle, must not be removed or
covered.
Always check that nuts and bolts are tight before starting the machine.
Only use the machine in places where it can be operated safely!
Before starting motor:
Remember to use petrol mixed with oil!
The motor in this machine is a 2-stroke motor which requires petrol mixed with oil.
Note! For the first ten hours use mix 1:20 = 5% octane 95 unleaded
Follow the oil supplier s guidelines. NEVER use ready-mixed moped petrol.
Be careful of rotating blades
Using the machine on steep slopes is dangerous!
9
Page
9
10
11
11
11
12
12
13
14
35