OK. OSF 4331 W Mode D'emploi page 13

ASSEMBLING AND MOUNTING
Assemble the two foot parts crosswise. Remove the four screws from the foot parts.
1
Use the four screws to mount the extension pole onto the feet. Then remove the clamping nut.
2
Slide the stand cover over the extension pole onto the feet. Pull out the extension pole and secure
3
it by installing and fastening the clamping nut.
Attach the motor unit to the extension pole and secure it with the thumb screw.
4
Remove the fan blade nut and the plastic nut from the motor unit.
5
6 Attach the rear guard to the motor unit with the handle facing up and the screw hole facing down
and secure with the plastic nut.
Slide the fan blade onto the motor shaft so that the pin locks to the groove. Secure the fan blade by
7
tightening the fan blade nut onto the shaft.
Open the clips on the front guard and remove screw and nut.
8
Hook the front guard from top onto the rear guard, thereby aligning the screw holes at the bottom
9
of the guards. Install the screw and nut to lock the guards.
10 Make sure all the clips are closed.
11 Place on a stable level surface. Set the desired angle.
OPERATION
12 Plug in the product.
13 To switch the fan on, select speeds 1-3. To switch fan off, press 0.
14 Push the oscillation knob to activate oscillation function. Pull the knob to stop the oscillation.
Caution:
• The product may only be connected to the mains once it has been completely assembled.
• The product must not be disassembled during operation, general care, cleaning and user
maintenance.
• The product may never be operated without the stand or in a horizontal position.
• Switch off and disconnect the product before adjusting height or desired angle.
• The guard must be completely closed when operating the product.
• During operation, do not put fingers or other objects in the guard.
• Unplug if it is not used for some time.
DISASSEMBLY
Disassemble the fan for cleaning in reverse order of assembly steps.
IM_OSF4331W_161101_V03_HR.indb 13
All manuals and user guides at all-guides.com
13
EN
1/11/16 12:02 PM