Publicité
Les langues disponibles
Les langues disponibles
Reflective mark
Cut the adhesive tape into squares of approximately 12mm (0.5") and apply one square to
each rotation shaft.
a. The non-reflective area must always be greater than the reflective area.
b. If the shaft is normally reflective, it must be covered with black tape or black paint before
attaching reflective tape.
c. Shaft surface must be clean and smooth before applying reflective tape.
Very Low RPM Measurement
To improve repeatability of low RPM measurements, it is recommended to apply additional
squares of reflective tape. Divide the reading shown on the display by the number of pieces
of reflective tape squares to calculate the actual RPM.
6. Warning
To avoid eye injuries, do not point the laser beam towards eyes or look directly into the beam.
Remove the battery if the instrument is not being used for an extended period of time.
Note :
If the battery current is weak, "BAT" symbol will be indicated on LCD display when you
press "MEM" button to make measurement.
Be careful not to allow any liquid or moisture to get inside the tachometer.
MTP Instruments warrants this instrument to be free of defects in parts and workmanship for
one (1) year from date of shipment. This warranty does not apply to defects resulting from
action of the user such as misuse, improper wiring, operation outside of specification, improper
maintenance or repair, or unauthorized modification. MTP Instruments specifically disclaims
any implied warranties or merchantability or fitness for a specific purpose and will not be held
liable for any direct, indirect, incidental or consequential damages. MTP Instruments total
liability is limited to repair or replacement of the product.
MTP Warranty Clause
Publicité
