ALPATEC VT 30 Notice D'utilisation page 13

All manuals and user guides at all-guides.com
notice VL-VP:notice VLP 16
VT 23 / VT 30 / VT 40
> BLADE AND GUARD:
- Remove the lock nuts and from the motor shaft if needed.
- Insert the rear guard on the axis with the help of locating pins. Fix with the lock nut.
- Insert the fan blade on the shaft till it hurts the stop pin. Fix with the lock nut (not for model VT 23) by tur-
ning in anti-clockwise direction. Check that the fan blade rotate freely by pushing with your hand.
- Open the securing clip and assemble front and rear guard. Close the clip and tighten the screw.
> BASE: only for models VT 30 / VT 40
- Assemble the bottom of the fan body and the base, and then fix with the supplied screws.
VP 40
> BLADE AND GUARD:
See paragraphe "Blade and guard" for VT 23 / 30 / 40 models.
> BASE:
- Remove the 4 screws from the bars. Then cross bar A onto bar B.
- Assemble outer tube to the bars with supplied screws.
- Remove the lock nut from the inner tube. Slide the plastic mask down over the assembly.
- Replace the lock nut on top of the inner tube. Pull the inner tube out from the outer.
- Put the head of the fan into the inner tube and tighten the set screw. Make sure the set screw is tightly
secured.
23/09/11 9:59 Page 13
ASSEMBLY
13