Trouble Shooting - Nilfisk Ecolab Typhoon Manuel D'entretien

6. Trouble-shooting
6.1 Machine does not start
Steps 1 - 3
Is there voltage
1
to the unit?
Is the fuse of the printed
2
circuit board intact?
Is the 'Δ' lamp on the
3
control panel turned off?
6.2 "Δ"- lamp on the control panel lights up
Steps 1 - 5
Is the fuse on the printed
1
circuit board intact?
Is the motor overload
2
protection - in the control
box - turned off?
NOTE: On the Typhoon Dual equipment the "∆" lamp on the control panel lights up, if the 3 phases are not con-
nected correctly.
Shift the phases on the phase shifter plug. Reconnect plug.
All manuals and user guides at all-guides.com
Reconnect the voltage
to the unit
Replace the fuse
Go to section 6.2
Call a service technician
Replace the fuse
Turn it on again
Call a service technician
21