Publicité
Les langues disponibles
Les langues disponibles
OC 9131
REAR PARKING SENSOR PUNCH TOOL KIT SKODA (10 PCS)
INSTRUCTIONS
Always adhere to the vehicle manufacturer's recommendations and repair instructions!
• As a rule, the position of the sensors is marked by the manufacturer with markings on the inside of the
bumpers (Figures 1+2). The supplied assembly tool set may contain a template suitable for the vehicle and/or
the bumper.
1
•
Use
a
Ø10
mm
Place the drill exactly in the middle of the marking and drill from the inside to the outside (Fig.3).
• Select the bushing suitable for the hole and insert it on the threaded pin with bearing. The opening of the
matrix should face the direction opposite the bearing (Fig.4).
3
• Insert the drive unit with the threaded part into the
hole previously drilled in the bumper (Fig.5).
2
drill
to
drill
a
4
5
hole
for
each
marking
on
the
bumper.
Publicité
