Before Use - Omega Lift Equipment 30750 Instructions D'utilisation Et Manuel De Pièces

BEFORE USE

1. Before using this product, read the owner's manual
completely and familiarize yourself thoroughly with the
product and the hazards associated with its improper use.
2. Verify that the product and the application are compatible,
if in doubt call Omega Tech. Service (888) 332-6419.
3. Inspect engine stand before each use. Do not use if there
are bent, broken or cracked components (including labels).
4. Ensure that casters/ wheels and adapter plate rotate freely.
Check for and tighten any loose assemblies.
! WARNING
• Study, understand, and follow all instructions
provided with/on this device before use.
• Do not exceed rated capacity.
• Use only on a hard, level surface.
• Lock head plate rotating mechanism before
applying load.
• Use only hardened, appropriately sized bolts to
secure engine to stand.
• Ensure engine is centered and secured to the
head plate. Off-center loading may cause the
engine to rotate unexpectedly and cause the
loaded stand to tip over.
• Unlock and apply rotating mechanism slowly and
carefully.
• Do not modify nor substitute hardware to this
device.
• Only attachments and/ or adapters supplied by
the manufacturer shall be used.
• Do not use the device for any purpose other
than that for which it is intended.
• Model 31256 does not contain a rotating
mechanism lock.
Extraordinary care must be taken to ensure
load does not rotate when using!
• Failure to heed these markings may result in
personal injury and/or property damage.
! WARNING
To avoid crushing and related injuries:
NEVER work on, under or around a
load supported only by engine crane.
ALWAYS use adequately rated engine
stand.
OPERATION
WARNING: ALWAYS verify that the product and the
!
application are compatible. NEVER load the engine
stand with an engine that extends beyond an imaginary line
drawn connecting the centerlines of the front and rear wheel/
caster axles as show in Fig 9.
Figure 9 - Perpheral Loading Limit of Engine Stand
WARNING: Ensure Lock pins are installed and secured
!
in front legs (as shown in fig. 1 & 2) before loading!
1. Ensure application is compatible with product.
2. Align engine with stand, then adjust mounting arms to
match bell housing mounting bolt holes. For model 30750,
31250, rotational lock must be secure before applying load.
3. Carefully secure engine so that load is centered on stand.
Secure with high strength stud bolts and flat washers.
Ensure threads are compatible with your engine, and use
washers on both sides of head plate.
4. To rotate engine slowly and carefully release locking
mechanism. Use original handle to rotate, then secure
by engaging lock mechanism (see Fig. 1 & 2). For model
31256, slowly and carfully engage the crank handle (see
Fig. 8)
5. Check to ensure stand is secure before working on or
around stand. Never work under loaded stand.
NOTICE: Use only the handle provided by the manufacturer.
The handle provided with this stand will safely engage
and operate the head plate. If the handle is worn, bent, or
otherwise damaged, STOP, discontinue use of the stand until
a factory replacement handle assembly can be acquired.
MAINTENANCE
Periodically inspect each stand. Ensure all parts move freely.
Lubricate the casters periodically. To help prevent rust, wipe
clean after each use.
WARNING: Paint contains lead!
!
DO NOT sand or grind painted surface!
Storage
Store the engine stand in clean, dry environment.
8