GE OPAL01GEPKT Manuel D'utilisation page 8

Care and Cleaning
System Cleaning / Sanitizing Procedure
(continued)
8. Touch the display button to start the cleaning process,
the light will start to spin and you will hear water
circulating. After three minutes the water will stop and
the light will begin to pulse again.
9. When the light pulses, drain Opal.
10. U nhook the top of the drain hoses at the back of the unit.
See figure 5.
11. Then lay them down to drain into a sink or bucket that is
below the level of the ice maker. See figure 6 and 7.
12. R emove the plugs and allow the water to completely
drain. See figure 7.
13. O nce water stops flowing, re-insert the drain plugs.
14. Add five cups of fresh water to the water reservoir,
and touch the button. The light ring is divided into four
sections to indicated each stage. Successive quarters
of the ring will become brighter with each rinse cycle.
15. R inse three times with fresh water. Repeat steps 8
through 14 two more times, adding fresh water to the
reservoir each time. (You may continue to repeat the
rinse cycle, for as many times as you like.
16. R eplace drain tubes on back. See figure 8.
17. W hen complete, slide the rear switch back to "Ice" mode.
See figure 9.
8
Display
Pull up to unhook
Figure 5
Figure 6
Figure 7
Replace drain tubes
Figure 8
Cleaning Ice
Figure 9
49-1000418 Rev. 6