General Guidelines; Technical Specifications - SX Lighting MF 900 Notice D'utilisation

GENERAL GUIDELINES

- This device is designed for professional use on the stage, in the disco, theaters... The device should only be used
indoors with an alternating current.
- Do not shake the device. Avoid brute force when installing or operating the device.
- Select a location where the device is protected against extreme heat, dust and moisture.
- Familiarize yourself with the functions of the device before actually using it. Do not allow operation by unqualified
people.
- Use the original packaging if device is to be transported
- All modifications of the device are forbidden for safety reasons.
- Only use the device for its intended purpose. All other uses may lead to short circuits, burns, electroshocks, crash...
Using the device in an unauthorized way will void the warranty.
- This device is not suited for permanent operation. Frequent operation breaks will protect the life span of your
smoke machine.
INSTALLATION
- Have the device installed by a qualified person, respecting EN 60598-2-17 and all other applicable norms.
- The carrying construction must be able to support 10 times the weight of the device for 1 hour without deforming.
- Never stand directly below the device when it's being mounted, removed or serviced.
- Have a qualified technician check the device once a year and once before you bring it into service
- Install the device in a location with few passers-by that is inaccessible to unauthorized people.
- Adjust the desired inclination angle via the mounting bracket and tighten the bracket screws.
- Make sure there is no flammable material with a 50cm radius of the device
- Connect the device to the mains with the power plug
- The installation has to be approved by an expert before the device is taken into service

TECHNICAL SPECIFICATIONS

Voltage: AC220V-230V/50Hz
Power: 900W
Pre-heating time: 4.5 minutes
Smoke output: 10000Cu Ft/min (283m
Capacity of tank: 0.8l
Gross weight: 3.7kg
Dimensions: 300 x 250 x 180
USE
- Add fluid carefully to the liquid tank. Do not overfill the tank
- Plug the remote control cord into the slot marked remote control on the back of the machine.
- Plug the power cord into a grounded electrical outlet. Turn the power switch 'ON' on the back of the machine. The
red light on the remote will turn on. The unit will take a couple of minutes to warm up the heater. During this time
the machine cannot generate fog. The green light on the remote control will turn on once the machine is ready to
produce fog.
- Your model includes a mounting bracket designed for overhead installation: it may be installed at floor level or
suspended overhead. If the unit is to be mounted suing the bracket, it is important that the fog does not shoot
directly at anyone's face. Whatever installation method you choose, do not allow the unit to have more than 25°
angle of inclination.
All manuals and user guides at all-guides.com
3
/min)