Safety Instructions - SX Lighting MF 900 Notice D'utilisation

PRODUCTS DESCRIPTION
This smoke machine adopts electronic temperature control, regularity in timing and volume, fits for pub, KTV and small
theater,... Thermostatic function lies with using computer electronic temperature, it sprays smoke at any time afterheating
for the first time. Adopt new heating core technology to make sure pipe never blocks.
NOTES BEFORE USE
- Place the smoke machine horizontally and check whether it is damaged or not; If damaged, please contact the
supplier at once. Unscrew the lid of the oil tank to pour the high-quality smoke liquid, and then fasten the lid
- Before power on, please verify that the supply voltage is in conformity with the rated voltage of the smoke
machine. The power supply should be connected to the grounding wire. When power on, the indicator light will
turn on, and the smoke machine will begin to work. Connect the machine to different controllers for different
controls.
- At first use, it is normal if the smoke machine creates just a little smoke or some steam.
- Place the smoke machine in a ventilated place but not in a hole, or else the machine's temperature fuse will be
disconnected and caused stop-heating.
- Place the smoke machine on the ground horizontally or install it on the hanger, but no aslant. The machine should
keep a minimum of 40cm distance all around. Keep it off kids, flames, flammable and explosive materials.
- Add liquid in time. If the smoke machine keeps running when the liquid is used up, it will cause damages to the
pump and the heater. Turn off the power before adding liquid and operate carefully : liquid overflow could cause
short circuit
- In case smoke is diminished, or there is noise from pump, or the machine stops smoking, please disconnect the
power at once, and check the liquid deposit, fuse, cable and power plug. If the problems are still not solved, please
contact the supplier.
- Do not touch the wire when the machine is running. It could cause electrical shocks
- Due to condensation, vapor or moisture might gather around the nozzle of machine.
- Please make sure there is no liquid and metals inside machine before turn on the power.
- Do not modify or repair the machine by yourself. If there is any problem, please contact the supplier.
INTRODUCTION
The disposal of the device after its life cycle could harm the environment. Do not dispose the unit as unsorted
municipal waste. It should be taken to a specialized company for recycling.

SAFETY INSTRUCTIONS

- Be very careful during the installation: touching live wires can cause life-threatening electroshocks.
- Do not touch the device during operation as the housing heats up
- Keep this device away from rain and moisture.
- Unplug the mains lead before opening the housing
- Damage caused by disregard of certain guidelines in this manual is not covered by the warranty and the dealer will
not accept responsibility for any ensuing defects or problems.
- A qualified technician should install and service this device
- Do not switch the device on immediately after it has been exposed to changes of temperature. Protect the device
against damage by leaving it switched off until it has reached room temperature
- Disconnect the device from the mains to clean it or when it is not in use. Handle the power cord by the plug only.
All manuals and user guides at all-guides.com