Cleaning And Care - Klarstein BUBBLE BOOST Manuel

EN
22

CLEANING AND CARE

• Disconnect the unit from the mains. Observe the safety instructions when doing so.
• After you have drained the water from the washing drum, set the control from "Pump
out" back to "Standard".
• Remove the lint filter and disassemble it by pressing on the bottom from the inside.
Clean the lint filter in warm water.
• Reassemble the lint filter after cleaning, put it back in place. Once it is seated
properly, you will hear a click.
• Disconnect the appliance from the water inlet and attach the drain hose to the
appliance.
• Rub down the casing. Use only mild cleaning agents for this.
• Close the cover and place the washing machine in a well-ventilated place.
Important cleaning instructions
• The electrical components of the appliance must not come into contact with water
during maintenance.
• If the power cable is damaged, it must be replaced immediately by a specialist
workshop.