Screen Saver - urmet domus 1093/061SVN Guide Rapide

IMPORTANT NOTE

THE DEFAULT PASSWORD IS "12345".

It is advisable to change the default password to prevent intrusions.

To enter/edit the password, remember to press "SHIFT" (make sure that the STATUS LED lights up) followed
by the number keys. At the end of the operation, press "SHIFT" to go back to default functions. The STATUS
LED will go out.

Do not lose or forget the programmed password.

Take note of the new password and keep it in a safe place.

It will not be possible to access the device in local mode (i.e. using the front panel) if an alphanumeric
password is chosen (using the dedicated software).
2.1.1.4

Screen saver

This option can be used to set the OSD (On Screen Display) display time.
Use "▲▼" to select.
Possible selections: "1min", "2min", "5min", "10 min", "20 min", "30 min" and "never" (OSD is always shown – press "ESC" to
quit the menu).
2.1.1.5 Video standard
This option can be used to select the video format. Use "▲▼" to select. Possible selections are "NTSC" and "PAL".
2.1.1.6 Enable scaler
This function allows to adapt the DVR video output display to the screen being used. Furthermore, by enabling this function, the
DVR automatically switches the resolution from 704x576 to 640x576 for PAL video systems and from 704x480 to 640x480 for
NTSC video systems. This function may be useful if some types of traditional CCTV monitors are used (CRT).
Press "ENTER" or "EDIT" to enable or disenable the password.
Symbol "" indicates that the selected option is enabled; symbol "×" indicates that it is not
2.1.1.7 Brightness
This option can be used to vary the OSD menu brightness. Use "▲▼" to select.
2.1.1.8 Menu trasparency
This option can be used to vary the OSD menu transparency level.
Use "▲▼" to select. Possible selections: "1:1", "3:1", "1:3"and "No Trans".
3:1 indicates that the OSD prevails (by approximately three times) over the previous display; 1:3 indicates the opposite.
2.1.1.9 Date / time
This option is used to set the current date in day/month/year format and to set the current time in hour/minute/second format.
Press "◄►" to select the day, month, year and hours, minutes, seconds.
Use the number keys 09 on the front panel to enter the date.
This option is used to automatically set time changes (to and from summer saving time).
When the "ORA LEGALE" is on, the clock will be automatically set back by one hour when winter time comes into effect, while it
will be automatically set forward by one hour when summer saving time comes into effect.
Press "ENTER" to access the submenu. Symbol "" in the check box indicates that the setting is enabled; symbol "×" indicates
that it is not.
Press "◄►" to go from one submenu option to another and press "▲▼" to set. Select "CONFIRM" and press "ENTER" to make
the changes effective.
After confirming the setting, in live and play modes, letter "E" or "I" will appear by the side of the date/time indicating summer
(when summer saving time is applied) or winter (when it is not) as shown below:
DS1093-029
All manuals and user guides at all-guides.com
Figure 25: date/time menu
39