ALPATEC CT 3000 S Notice D'utilisation page 11

notice_CT 3000 S: notice_CT3000
- The switch is located under the base of the device:
- O .... Off
- I .... On
1. Assemble the device as described above.
2. Plug it into a waterproof outlet after having verified that the voltage corresponds to the
indicated voltage.
3. Press the On button.
1. Turn the device off and unplug it. If the device was on before cleaning, wait until it has
cooled down so you do not burn yourself.
2. With a soft cloth, carefully clean the device. Never use alcohol, solvents or acids such
as vinegar or abrasives.
Issues
The device will not
turn on.
The device does not
work, but the current
passes through.
The device functions,
then suddenly stops
functioning.
Model
Voltage
Power
Protection
19/12/12 9:46 Page 11
OPERATIONS
OPERATIONS
MAINTENANCE
MAINTENANCE
TROUBLESHOOTING
TROUBLESHOOTING
Potential causes
The device is not
plugged in properly.
The plug is defective.
An object is preventing the
On/Off button from working
properly.
Verify your electrical
power system/fuse/circuit
breaker.
SPECIFICATIONS
SPECIFICATIONS
CT 3000 S
230 V – 50 Hz
3000 W
IPx4
11
Solutions
Remove the plug and plug
it in again properly.
Have it replaced by an
electrician.
Place it on a flat and stable
service. Look for the object
to be removed.
Have it checked by an
electrician.