Additional Warnings - Bernzomatic BZ8250HT Manuel D'instructions

ADDITIONAL WARNINGS


• Make sure the torch is cool before installing or removing cylinder and accessories. Using a low flame can cause
damage to the burn tube and ignition system.
• Check all joints and couplings periodically to insure against loose connections. With valve open, without lighting,
test all connections with soapy water. If bubbles appear, gas is leaking and torch must be repaired or replaced.
NEVER USE A FLAME TO CHECK FOR LEAKS. Make this test in a well ventilated and spark-free area and where
there are no open flames.
• In cold weather the size of the flame will be smaller. To produce a larger flame, pre-warm the cylinder
to room temperature prior to use.
STORAGE
REMOVE CYLINDER FROM TORCH WHEN NOT IN USE
1. Turn ignition button to the off position. Make sure regulator valve is closed by turning flame adjustment knob fully
clockwise until it stops. Do not force.
2. When torch is cool, disconnect cylinder and store torch and cylinder separately and out of reach of children. Observe
cautions on cylinder label.
3. Do not expose cylinders to temperatures in excess of 120ºF.
4. Store cylinders in well ventilated areas.
LIMITED LIFETIME WARRANTY
Bernzomatic warrants to the original purchaser that this product is free from defects in material and workmanship for as long
as you own your TS4000, TS7000, T757, TS8000, BZ4500HS, or BZ8250. This warranty is valid for all purchases of the TS4000,
TS7000, T757, TS8000, BZ4500HS, and BZ8250 on or after June 1, 2016. This warranty does not apply to product that has been
damaged as a result of improper maintenance, accident or other misuse, or which fails to operate due to normal wear and tear.
This warranty is void if the product is repaired or modified in any way by anyone other than Bernzomatic.
Bernzomatic will repair the product if it proves to be defective in materials or workmanship. At the choice of Bernzomatic,
a replacement product may be provided instead of repairing a defective product. The sole obligation of Bernzomatic and
your exclusive remedy under this warranty are limited to such repair or replacement.
To make a claim under this Limited Lifetime Warranty, contact any Bernzomatic retailer or contact Bernzomatic directly at
1-800-359-9678. A service representative will assist you. Please provide proof of date of purchase when making a claim.
Bernzomatic makes no other warranties concerning the product. In no event shall Bernzomatic be liable for incidental or
consequential damages. Some states do not allow the exclusion or limitation of incidental or consequential damages, so
the above limitation or exclusion may not apply.
This warranty gives you specific legal rights, and you may also have other rights which vary from state to state.
DO NOT DISCARD THESE WARNINGS AND INSTRUCTIONS | NE PAS JETER CES AVERTISSEMENTS ET INSTRUCTIONS
NO DESECHE ESTAS ADVERTENCIAS E INSTRUCCIONES | NÃO DESCARTE ESTES AVISOS E INSTRUÇÕES
200 Old Wilson Bridge Road | Columbus, OH USA 43085
(866) 928-2657 | worthingtoncylinders.com | bernzomatic.com
08/19/16