FONESTAR MA-400RGUZ Mode D'emploi page 3

8: in radio mode, a short press of this button selects the next frequency point in 0,05 MHz steps.
3.-
A long press of this button makes an automatic search for the next station. In playback mode, it
jumps to the next track after the one being played at that moment.
VOL+/VOL-: USB/SD/MP3 player volume control and digital FM tuner.
4.-
MP3/FM: pressing this button changes alternatively between the two available audio sources
5.-
(USB/SD/MP3 player or FM radio).
6.- USB storage device connection port.
7.- SD memory card reader.
REC (MEMORY): button which allows a recording of the inputs AUX 1-2 and INPUT 1-4. Follow the
8.-
steps decribed below to carry out this recording:
- Connect a USB storage device or an SD memory card. Then
press the REC button to start recording.
- In the display the word REC will be shown.
- Press the SD/USB button to select the memory device where the recording will be stored.
- Select the required recording level with the REC LEVEL control.
- Press the REC button again. Once the word REC flashes 3-4 times in the display, recording
will begin.
- Press the 3 button to finish the recording.
Note: the recordings are saved in a file named MP3_REC with consecutive numbers
(REC_001L.mp3, REC_002L.mp3, etc). If in the display Err is shown during the recording, this
indicates that an error has occured. In this case press the 3 button to stop the recording.
In radio mode, it allows a certain radio station to be memorized. In order to do so, tune the required
radio station and press the MEMORY button. Then press one of the M1-M4 buttons and the station
will be stored in the memory position selected.
12: starts and pauses playback.
9.-
10.- RPT: press this button repeatedly to select one of the following playback modes: deactivated
repeat, random play (RANDOM), repeat all (ALL) and repeat one track (REP 1).
11.- SD/USB: selection of audio source between SD card or USB storage device.
12.- q/3: button to switch the USB/SD/MP3 recorder/player on or off. Press this button for
approximately 3 seconds to switch the module on or off. In playback mode, it stops playback.
CHIME: button to activate chimes.
8.-
Note: The contacts CHIME PRIORITY on the rear panel must be closed for the chimes to be played.
SIREN: button to activate the siren signal.
9.-
10.- ZONE PAGING SELECTOR: buttons which allow the zones where the audio will be played to be
selected. The zones can be selected individually (Z1-Z5) or all at the same time (ALL).
11.- POWER: amplifier on/off button.
- 3 -
EN