D User Manual - brennenstuhl 1171730 Manuel Utilisateur

053820 BA_Solarleuchte Leadpad.qxp

D User Manual

Multifunctional Solar LED Flood Light
Please read and follow all instructions to operate.
Save this manual for future reference.
INSTALLATION
Drill 2 holes of
Wall Mounted
cp8mm an the wall
1. Prepare lamp, accessories and tools weil firstly.
2. Use the allen wrench to loosen the bracket (see picture
(see picture
3. Use the allen wrench to loosen the light panel, pull it out and adjust to your demanded lighting
angle(see picture
4. Fix the lamp onto the wall or lamp-post (see picture
NOTICE & WARNING
1. This is a solar powered lamp, please install it in a location where can get enough sunshine.
2. Please note the lighting time depends an sunshine duration & weather.
3. The lamp will light up automatically at dusk.
4. Built-in intelligent IC is with over-charge, over-discharge and over-voltage protection.
5. The lamp is equipped with an internal battery pack, which is replaceable. lf any need, please
contact seller for correct new battery pack.
6. lf the battery is taken out and put back in or replaced with new ones, please toward the solar
panel to sunshine or a strong light to activate the lamp.
7. Non-professionals please da not disassemble the lamp.
8. Please da not dispose the battery with household garbage to avoid explosion.
22.12.20
6
) and then fix the screw tightly (see picture
), then fix the screws tightly (see picture
12:20 Seite 5
It's workable for both
©
round lamp-post (Dia-
meter 40-60 mm) and
{
square lamp-post
Lamp-post Mounted
(Side length 30-40 mm)
, adjust it to the appropriate angle
).
).
).
5