Technical Data - Jula 071029 Mode D'emploi

• Mounting pieces can be thrown out, causing
serious injury or damage to property.
• Poorly maintained tools and accessories can
cause malfunctions that result in serious
personal injury.
Damaged tools can shatter during use.
•
Only use accessories recommended by the
•
manufacturer for the specific tool.
Always wear ear protection.
The declared vibration and noise value, which has been measured by a standardised test method, can be
used to compare different tools with each other and for a preliminary assessment of exposure. The
measurement values have been determined in accordance with EN ISO 11148-7-2012.
WARNING! The actual vibration and noise level when using power tools may differ from the specified
maximum value, depending on how the tool is used and what kind of workpiece is processed. It is
therefore necessary to determine which safety precautions are required to protect the user, based on an
estimate of exposure in actual operating conditions (taking into account all stages of the work cycle, e.g.
the time when the tool is switched off and when it is idling, in addition to the start-up time).

TECHNICAL DATA

Sanding disc
Speed (no load)
Average air consumption
Operating air pressure
Air intake
Air hose
Total length
Net weight
Sound power level, LwA
Sound pressure level, LpA
Vibration level
ENGLISH
• Never point the tool's outlet opening at
yourself or at anyone else.
Never press the trigger unless the tool's
•
contact safety catch is pressed against the
workpiece.
Never attempt to drive mounting pieces into
•
hard materials such as steel, concrete or
tiles/clinker.
Never drive in a mounting piece on top of
•
another one.
Position the tip of the tool carefully, so that
•
the mounting pieces are driven in at exactly
the right place.
• Maintain the tool in good order.
• Keep cutting tools sharp and clean. Properly
maintained cutting tools with sharp cutting
edges are less likely to jam and are easier to
control.
Make sure that moving parts are properly
•
adjusted and do not jam and that no parts
are incorrectly fitted or damaged. Check for
other factors that could affect the operation
of the power tool. If the tool is damaged, it
must be repaired before being used again.
Accessories that are not intended for the tool
•
can cause personal injury.
125 mm
11,000 rpm
170 l/min
6.2 bar
1/4"
3/8" inner diameter
230 mm
1671 kg
98 dB(A), K= 3 m/s
87 dB (A), K= 3 m/s
2,43 m/s
31
2
2
, K= 1,5 m/s
2 2