Grounding Instructions; Important Warning - Simplicity SCR412BL Mode D'emploi

ATTENTION
GROUNDING INSTRUCTIONS
This appliance must be grounded.
In
the event of an electrical short circuit,
grounding reduces the risk of electrical
shock by providing an escape wire for the
electrical
current. This appliance
is
equipped with a cord having a grounding
wire with a grounding
plug.
The plug must
be plugged into an outlet that is properly
installed and grounded.
WARNING - lmproper use of the
grounding plug can result in a risk of electric
shock. Consult a qualified electrician or
serviceman
if
the grounding instructions
are
not completely understood, or if the doubt
exists as to whether the appliance
is
properly grounded.
DO NOT USE AN EXTENSION
CORD
Use an exclusive wall
outlet.
Do not connect
your refrigerator to extension.cords or
together with any other appliance in the
same wall
outlet.
Do not splice the cord.
IMPORTANT WARNING
An empty refrigerator is a very dangerous
attraction to children.
Remove either the
gasket, latches, lids or doors from unused
appliances, or take some other action that
will guarantee it harmless.
DANGER: Risk of child entrapment. Before
you throw
alvay
your old
refrigerator
or
freezer:
.
Take off the
doors
.
Leave the shelves in
place
so
that children rnay
not
easily climb
inside.
DON'T WAIT!
DO IT NOW!
Location
1. Select a place with a strong, level
floor.
2. Allow 5
inches of space between the back of
the refrigerator and any adjacent wall.
3.
Avoid direct sunlight and heat.
Direct
sunlight may affect the acrylic coating.
Heat sources nearby will cause higher
electricity consumption
.
4.
Avoid very moist places.
Too much moisture
in
the air will cause frost to form very quickly
on the evaporator, and your refrigerator will
have to be defrosted very frequently.
To avoid vibration, the cabinet must be set
levef
.
To start the refrigerator, turn the temperature
control to the position corresponding to the
desired cooling. The refrigerator temperature
will vary depending on the quantity of the food
stored and on the frequency with which the door
is opened.
Tu
rn
the control to the
IsO"
position to
temporarily disconnect the cooling cycle. After
defrosting and if the refrigerator has been left out
of use for some time, set the controf to maximum
lor 2 to 3 hours before turning to the desired
position. When the refrigerator is not to be used
for a long period of time, disconnect the plug
and
leave the door partially open.
Note: Wait 3 to 5 minutes before restarting
if
operation has been interrupted.
lce Cubes
lce cube tray is ffexible.
Twist tray to remove ice
cubes.
lf the ice cube tray is frozen hard to the
evaporator surface, run a little water over the
tray.
Never use a knife or other metal instrument to
remove ice cube tray because this rnay damage
the evaporator. (Fig. C)
Fig.
C
Remove the exterior and interior packings, wipe
the outside thoroughly with a soft dry cloth
and
the inside with a wet, lukewarm cloth.
Avoid
pfacing the cabinet in a narrow recess or near
any heat source, direct sunlight, or moisture.
Let air circulate freely around the
cabinet.
Keep
the rear
of
the refrigerator 5 inches away from
the wall.