System Installation; Connect Camera To Lcd Monitor - Sailor SA-555 Manuel D'utilisation

E
NGLISH

System installation

Receiver:
1. Plug the Cigarette Adaptor Cord into the DC Input Jack at the bottom corner of the
LCD monitor.
2. Plug the Cigarette Adaptor into the cigarette power source besides the driver's seat
in the condition of starting engine.
3. A/V input on the LCD monitor can be connected to VCD/DVD player for entertainment.
4. A/V output on the LCD monitor can be connected to DVR for recording.
Camera:
1. 1. Connect the Din connector from the camera with the Din connector from 60 ft
Din-Phone jack cable, plug the other end of phone jack cable to the monitor's AV-in
jack on the display.

Connect Camera To LCD monitor

All manuals and user guides at all-guides.com
®
SAILOR SA-555
Video Security Systems
40
®
SAILOR SA-555
Video Security Systems
System Setup:
1. The Hard-Wired 7" Colour TFT Car Rear View System can be set up in various
vehicles and operated only while the vehicle is in reverse condition.
2. The LCD monitor can be connected up to two different channels for reception, and
display them in selected channel or auto sequence at 5 sec intervals.
A) Single Channel Display
When one camera is installed:
1. Pre-set single channel by factory default is indicated by Channel Display Sticker.
2. Select the particular channel related to installing camera by gently pressing the
channel selection button located on the side of the LCD monitor.
3. Selected channel is displayed on the LCD monitor in accordance with the installing
camera.
B) Two Channels Display
1. Turn on the monitor, the monitor will auto-detect two channels, and enter into auto
scan mode (5 seconds interval between CH1 & CH2)
2. Select the channel you wish to watch; simply by pressing the channel selection
button on monitor for desired channel (1st, 2nd press).
3. For auto-scan channel selection with 2nd press to the channel selection button on
the LCD monitor CH1, CH2 are displayed for Camera 1 & 2 with 5 sec intervals
repeatedly.
Channel 1 for Camera 1
Single channel
display
Monitor Set to
Channel 1
Channel 1 for Camera 1
Auto scan
display
Monitor Set to
Channel 1
E
NGLISH
To Press 1,
Channel 2 for Video Input
or
Monitor Set to
Channel 2
To Press 1,
Channel 2 for Video Input
Monitor Set to
Channel 2
41