Charging Instructions - ReadiVac STORM RH1000 Manuel D'instructions

DO NOT use the unit with a damaged
charging cord or plug. If vacuum is not work-
ing as it should; has been dropped, damaged,
left outdoors, dropped into water, return it to a
service center.
DO NOT drop or throw the unit. Treatment of
this type can cause damage to the
nents and create hazardous conditions.
Use extra care when cleaning on stairs or lad-
ders.

CHARGING INSTRUCTIONS:

WARNING: Use the charging device and charging dock (base) supplied with this
ReadiVac™ product. Failure to follow these instructions may result in
fire or serious bodily injury.
1) Ensure the vacuum cleaner power switch is in the OFF position.
2) Place the vacuum into the charging dock. Ensure that it 'seats' properly over the charging pin.
3) Plug the power adaptor into an electrical wall outlet. The LED light should illuminate solid RED to indicate
the vacuum is charging.
4) Charge the product for at least 6 hours before its first use.
5) Charging time after its first use should be limited to 5-7 hours.
6) Once fully charged, the LED will (depending on the model) turn GREEN or BLINK RED. The vacuum should then
be removed from the charging dock.
7) For maximum vacuum motor efficiency the unit should be run 6-10 complete cycles.
This ReadiVac™ product has a Lithium-Ion battery pack that is designed for power storage between
uses. It is recommended that you remove the vacuum cleaner from the charging dock and unplug the charging
adaptor from the wall after charging. Leaving the appliance plugged into in the charging dock for long time
periods beyond the charging cycle can damage the batteries and charger over time. The charger also consumes
electrical power when in standby. Unplugging the charging dock will help to conserve energy.
OPERATING INSTRUCTIONS:
WARNING: DO NOT pick up anything that is burning or smoking,
such as cigarettes, matches, or hot ashes. Failure to follow these
instructions may result in serious bodily injury.
1) Slide the switch forward to turn the vacuum ON.
2) For wet or dry pick-up, suck water or other liquid into the dust cup
ensuring not to exceed the MAX fill line denoted on the dust cup.
3) Slide the switch backward to turn the vacuum OFF when cleaning has been completed.
Note: When the dust cup is filled with liquid always carry it with the nozzle
pointed down and the handle pointed upwards to prevent spills.
compo-
Page 4 of 12