Before The First Use - Tristar ST-8911 Mode D'emploi

BEFORE THE FIRST USE

• Before the first use, please remove any sticker
or protective cover.
• Place your steam generator on a stable,
horizontal heat-resistant surface.
• For the first use, use the iron on an old piece of
fabric to ensure the soleplate and water tank
are completely clean.
• Never use the steam generator when water
tank is empty, refill it before use it again.
Fill the water tank
• Before filling the water tank, check if the steam
generator is cooled down, if the power cable is
unplugged and if the temperature knob is on
its minimum position.
• Note: never unscrew the boiler cap before
these three steps are done.
• During filling please do not exceed the
maximum water capacity (0.5L).
• Note: use a funnel to fill the boiler.
All manuals and user guides at all-guides.com
• Please read carefully our advices in chapter
• Open the boiler filter cap and fill the boiler with
• Screw the boiler filter cap tight.
• Notes: if the water tank indicator illuminates
• Never unscrew the boiler cap when the
Select the temperature
• Place the iron on its base.
• Select the desired temperature by using the
• Note: we advise you to read the chapter
"type of water to use" concerning the water to
use with your steam generator.
water.
and there is no steam the water tank is empty.
appliance is still connected to the power
supply.
thermostat knob, check the ironing symbols
on your clothes in order to adapt the ironing
temperature.
"Ironing of your linens" in order to select the
best ironing temperature.
Steam generator iron
EN
7