PUREGEAR AutoGrip Mode D'emploi page 2

Instructions:
Attaching the VENT MOUNT in your car
1. Unscrew the large socket nut and
push vent clip ball joint into the
hole until it snaps into place.
2. Screw the socket nut back on until
tight – this locks the vent clip onto
the wireless charging pad and holds
the adjustable support base in place.
3. Insert the USB-A plug into the car
charger, then insert the USB-C plug
into the wireless car charger.
4. Attach the mount by placing the vent
clip bracket onto an air vent in your
car and lock the mount by pressing
down on the lever.
NOTE: The lever has two settings. 1 is for thin vents, 2 is
for thicker vents. If vent clip does not feel secure,
adjust setting accordingly.
2
5. Plug the car charger into the cigarette
lighter socket to power on. The LED
light on the wireless pad will be green
when powered on.
6. Place your phone on the charging
pad with the bottom of your phone
resting on the support base, and the
arms will automatically close and
hold your phone in place.
NOTE: Adjust the support base accordingly to ensure
best charging position depending on your device.
7. To remove your phone, touch the
button on either side of the mount
and the arms will open automatically.
3