Speaker Connections - JVC KS-AX5700 Manuel D'instructions

SPEAKER CONNECTIONS

Connection varies depending on the number of the speakers used in your car. Select the
appropiate connection referring to the diagrams below.
Before connecting: Securely connect all the parts. If the connections are loose, due to contact
resistance etc., heat will break out and may cause an accident. Secure and cover the cords with
insulating tape and run them under the car mats.
• Depending on the manufacturer and model of the car, speaker wiring may have been fi nished
when purchased. If the ground wire is common to both left and right speakers, this unit cannot
be used. In this case, redo the speaker wiring.
å When your receiver is equipped with Line Output, connect the Line Output (through the
receiver) to the INPUT jacks on this unit.
∫ When your receiver is NOT equipped with Line Output, connect the speaker connector
(through the receiver) to the HIGH INPUT terminal on this unit.
KS-AX5500
4-speaker system
2-speaker system plus subwoofer—BRIDGE MODE
2-speaker system—BRIDGE MODE
L
L
* 2
* 2
KS-AX5700
2-speaker system
Subwoofer system—BRIDGE MODE
2-speaker system (2 amplifi ers)—BRIDGE MODE
1
* Not supplied for this unit.
* 2
BRIDGE MODE: Be sure to connect the line output from the receiver to the left (L) jack on this
unit.
3
*
Be sure to connect the both leads to the target speaker lead.
2
* 2
* 2