All Rights Reserved; General Warnings; Technical Specifications - Mark PinTherm Connect Livret Technique

2.0 General

2.1 All rights reserved

The manufacturer has a policy of continuous product improvement and reserves the right to
make changes to the specifications without prior notice. The technical details are considered
correct but do not form the basis for a contract or warranty. All orders are accepted subject to
the standard terms and conditions of sale and delivery (which will be sent to you at your request).
The information in this document is subject to change without notice. The most recent version of
this manual is always available at www.markclimate.com/downloads.

2.2 General warnings

Installation must comply with the relevant local and/or national regulations. You must therefore
have the PinTherm Connect installed by a professionally qualified installer in accordance with
all applicable national and international regulations. Faulty installation, adjustment, alteration,
maintenance activity or repair shall render the warranty void.
Always switch off the 230V power supply before connecting the terminals. The mains voltage
on the PinTherm Connect must be able to be switched off in a double-pole manner by means
of a permanent switch that is suitable for 250VAC / 10A and complies with the applicable safety
regulations.
Only devices that comply with EN-IEC 61010-1 may be operated with the PinTherm Connect.
Clean the housing of the PinTherm Connect with a damp cloth. Do not apply solvents.
There are no requirements regarding ventilation in the immediate vicinity of the controller.
Warning - risk of electric shock.
Warning - general warning, risk of danger.
!
There can be voltage on the connection terminals where a
3.0 Technical specifications
3.1 Technical specifications PinTherm Connect
• Type designation
• Item number
• Power supply PinTherm Connect :
• Own consumption
• Clock
• Switching programs
• Switching differential
• Dimensions
• Weight
• Protection class
• Installation environment
• Over voltage category
• Pollution level
• Switch contact(s)*
4
: PinTherm Connect
: 06 29 108
90 – 240 VAC / 47-63Hz
: < 9W
: 24 hour clock with automatic summer/winter time switching
: 3 switching programs a day
: 0,1 - 3K
: 166 x 160 x 106mm (bxwxh)
: 880 grammes
: IP-54
: Transport/storage: -20°C until +70°C.
Operational: -10°C until +60°C
Relative air humidity: 0-90% not condensating
Installation maximal 2000 meter above sea level.
: 11
: 2
: Heating: 230Vac/16A (4A)
Others: 230Vac/10A (2,5A)
!
is placed.