Worx Nitro WX102L Mode D'emploi page 11

OPERATING INSTRUCTIONS
NOTE: Before using the tool, read the
instruction book carefully.
INTENDED USE
The machine is intended for driving in and loosening
fasteners as well as for drilling in wood, metal and
plastic.
Assembly and Operation
ACTION
BEFORE OPERATION
Removing the battery pack
Charging the battery pack
Installing the battery pack
ASSEMBLY
CHUCK ADJUSTMENT
WARNING: Always lock off the On/Off
Switch and disconnect tool from power
source when changing accessories. Always ensure
the bit is secure before starting the tool. Damage
to the Chuck or a loose bit may cause possible
personal injury.
- Removing the bits
- Inserting the bits
- Assembling the belt hook
OPERATION
Forward/Reverse Rotation Control
WARNING: Never change the
direction of rotation when the
chuck is rotating, wait until it has
stopped!
TWO-SPEED GEAR CONTROL
WARNING: To prevent gear
damage, always allow the
chuck to come to a complete stop
before changing the direction of
rotation.
TORQUE ADJUSTMENT
Drilling, Screw driving
Operating the On/Off Switch
WARNING: Do not operate
for long periods at low
speed because excess heat will be
produced internally.
20V Cordless Brushless Drill Driver
LED Light Indicator
Before operation, the LED light will be
activated when the On/Off switch is
slightly depressed.
WARNING: To turn on the
light, press the On/Off switch
and make sure the Forward/Reverse
Rotation Control is on right/left
position.
The tool and battery are equipped
with a protection system. When
the LED Light is quickly flashing 60
FIGURE
seconds and turn off, the system
will automatically cut off power to
the tool to extend battery life. The
tool will automatically stop during
See Fig. A1
operation if the tool and/or battery
are placed under one of the following
See Fig. A2
conditions:
• Overloaded: The tool is operated
See Fig. A3
in a manner that causes it to draw
an abnormally high current. In this
situation, release the On/Off Switch
on the tool and stop the application
that caused the tool to become
overloaded. Then pull the On/Off
Switch again to restart.
• Overheated: Under the condition
above, if the tool does not start, the
Tool and Battery are overheated. In
this situation, let the Tool and Battery
cool before pulling the On/Off Switch
See Fig. B1
again.
• Low battery voltage: The
See Fig. B2
remaining Battery capacity is too low
See Fig.
and the tool will not operate. In this
C1, C2
situation, remove and recharge the
Battery.
PROBLEM SOLUTION
See Fig. D1,
D2, D3
1. WHY DOES THE DRILL NOT TURN ON WHEN
YOU PRESS THE SWITCH?
The Forward/Reverse Rotation Control, which is
on top of the On/Off Switch, is positioned in the
lock function. Unlock the Forward/Reverse Rotation
See Fig. E
Control by putting it into the required rotation
position. Push the On/Off Switch and the drill will
start to rotate.Check that the battery is charged and
properly connected to the tool.
See Fig.
2. THE DRILL STOPS BEFORE THE SCREW IS
F1, F2
COMPLETELY TIGHTENED. WHY?
Verify the position of the torque adjusting ring.
Find the torque adjusting ring between the chuck
See Fig. G
and the drill body. Position 1 is the lowest torque
(screw driving force) and position 18 is the highest
torque (screw driving force). Position
operation. Regulate the torque adjusting ring to a
See Fig. G
11
is for drill
EN