Areglio PRG383 Mode D'emploi page 9

Programmateur electronique monophasé-triphasé pour commande de portes motorisees
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

Container installation procedure
4A
• Remove the screws "B" and carefully extract the
P.C.B. card "C" from the container remembering
to store it somewhere safe from dust and
possible damage.
4B
• Using the container as a template mark the
four points at which the fastening holes are
to be drilled;
• Fasten the container using four screws and
raw plugs "G" and insert the screw covering
plugs "H".
• Insert the pipe fittings "D"
that they are fastened correctly.
4C
• Re-insert the electronic card into the container
and fasten down using the screws "B"
• Insert the rigid electrical connection pipes "I"
into the cable tubes. The 230V~/400V3 power
cables should be passed through pipes 1 and
2 (see figure) so as to separate them from the
low voltage wires which should be passed
through pipes 3 and 4.
• Carry out the electrical connection following the
attached wiring diagram (see fig. 5).
All rights reserved. Unauthorised copying or use of the information contained in this document is punishable by
Drawing number :
Product Code :
P.J.Heath
Draft :
CARDIN ELETTRONICA S.p.A - 31020 San Vendemiano (TV) Italy - via Raffaello, 36 Tel: 0438/401818 Fax: 0438/401831
(fig.4A)
and check
All rights reserved. Unauthorised copying or use of the information contained in this document is punishable by law
(fig.4A)
Drawing number :
DM0135
Product Code :
LPRG
Draft :
P.J.Heath
CARDIN ELETTRONICA S.p.A - 31020 San Vendemiano (TV) Italy - via Raffaello, 36 Tel: 0438/401818 Fax: 0438/401831
9
Description :
DM0138
Inserimento scheda PRG383
PRG
Date :
27-04-98
Description :
Installazione contenitore PRG
Date :
27-04-98
A
D
C
E
F
G
M
1 3 0 M
1
2
3
4
4
B
H
I

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

Zvl364.02

Table des Matières