Carmen MC2000 Mode D'emploi page 7

All manuals and user guides at all-guides.com
6 • ENGLISH
Set the control to the left position to cut hair or to the right
to thin hair.
CUTTING
LONGER
SHORTER
Choose the desired comb for you clipping attachment. The
millimetre of the comb depends on the desired hair length. If
you are clipping for the first time, begin by clipping with an
attachment of maximum length to prevent too short of a cut.
When you have familiarized yourself with the settings, use a
comb with less millimetre with lower length. Make sure that
the flat part of the comb is always in full contact with the
scalp to obtain an even result. Shave against the hair growth.
Pressing the comb against the head, start by clipping the
sides from the bottom of the head upwards. Slowly move
the clippers up towards the top of the head cutting small
amounts at a time. Continue doing this for both sides and the
back of the head. Clip the top of the head from front to back.
THINNING
> CLEANING AND MAINTRANCE
• Wipe the clipper surface with a wet soft cloth.
• Never immerse the unit and power adapter into water or
other liquids.
• Rub the attachments periodically with medical alcohol to
disinfect them.
• Cleaning the blades with the attached brush.
• When the blades are very dirty please remove the whole
cutting attachment and clean it under running water.
After drying it thoroughly, put the attachment with the
blades back on the clipper reversely.
• Put the clipper with the combs back to the original
package at a dry and dust free place, out of reach of
children and incapacitated people.