The Battery; Installing And Removing The Battery; Charging The Battery - Greenway 8965105 Manuel D'instructions

Please note: if you use the bike frequently, it is recommended that you inspect the state of
the fork, the frame, the suspension and the fasteners. The materials and components may
be subject to different reactions to usage and wear.
If you have any doubts, contact your dealer, who will proceed with the necessary inspection.

4.The battery

4.1) Installing and removing the battery

The battery is an important and costly part of the e-bike. It is
designed to be locked into position with a key to preventing
theft. You can take further precaution by removing the battery
while the e-bike is parked unattended. You may also have a
need to remove the battery from the e-bike to recharge it at a
location where you cannot park your e-bike.
To remove the battery: ① fold the bike ② insert the key into
the battery, hold pressing the key a bit until twist clockwise to
the end (Note:You can't remove the battery until the lock bar withdraws into the battery
completely); ③ slip off the battery ,the battery is quite heavy and you should take care not to
drop it.
To put the battery back into place, insert the battery along to the guide rails. Push it closely
against the controller box. Fasten the lock.

4.2) Charging the battery

Here are the steps to be followed when charging your battery:
Turn the battery off. The LED lights will be off.
Step 1
Plug the charger (which is off) into the socket and then insert the charger's plug into the
Step 2
battery, which is also off.
the charger's LED indicators lit up in the following manner:
Step 3
• The red LED lights on: the battery is being charged.(A)
• The red LED light becomes green:
the battery is full charged; you can unplug the charger. (B)
（ A : Red light ）
It takes 3 - 6 hours for the battery to be fully charged when using the standard charger that's supplied with
your bike.
（ B : Green light ）
8