Product Maintenance - Altair AL-2167 Instructions De Montage

TROUBLESHOOTING:
SYMPTOM
Lights do not come on or
flicker.
Lights stay on through the
day (or stay on late into the
day).
Fuse blows or circuit breaker
trips when light is turned on.

PRODUCT MAINTENANCE:

•
To clean the fixture, disconnect power to the fixture by turning off the circuit breaker or
by removing the fuse at the fuse box. Wait a few minutes for the fixture to cool down.
Use a dry or slightly dampened clean cloth (use clean water, never a solvent) to wipe
the glass and surface of the fixture.
•
Do not use any cleaners with chemicals, solvents or harsh abrasives. If necessary, use
a mild soap to clean off any dirt or stains.
THREE YEAR LIMITED WARRANTY

Altair Lighting
for three (3) years from the original date of purchase by the consumer. This warranty is
limited to the counter replacement at the time of purchase, with the original purchase
receipt. Altair Lighting
consequential damages of any kind, whether based on warranty contract or negligence, and
arising in connection with the sale, use or repair of the product claimed to be defective.
Some states do not allow the exclusion or limitation of incidental or consequential damages
so the above limitation may not apply to you. This warranty gives you specific legal rights
and you may also have other rights, which vary from state to state. Misuse, accident,
improper installation or maintenance will also void the warranty.
Warranty is only valid when the product is purchased directly from Costco. Warranty is non-
transferable and applies only to the original purchase of the product. Proof of purchase is
required for all claims. The warranty does not include labor costs to install, remove, or repair
the product. The warranty policy is subject to change without prior notice.
PROBABLE CAUSE
Wall switch and/or circuit breaker is off.
Incorrect or loose wire connections.
Light from another light source, such as a street
light or another light fixture, is shining onto the
photocell.
Component has malfunctioned.
Fixture may be installed in shaded area, such as
under a porch or an eave, and enough light is
shining onto the photocell during the daytime.
Crossed wires or power wire is grounding out.
warrants this product to be free from defects in material and workmanship

will not be liable for the loss or damage of any kind, incidental or
6
SOLUTION
Turn on wall switch and/or
circuit breaker.
Access outlet box and fix wire
connections.
Eliminate the light source or
move fixture to another
location.
Call Altair Lighting support.
Relocate fixture to a well lit
area.
Access outlet box and fix wire
connections.