Weidmüller PrintJet Mode D'emploi page 10

7. Enter the following values in the window that opens
subsequently:
Paper width: 2100 and paper height: 4000
8. Confirm your entries with OK.
9. Click on OK to close the printer driver.
4. Installing the M-Print software
Users who already have M-Print installed on their computer
do not need to reinstall the software.
1. Place the CD-ROM containing the drivers in your CD-ROM drive.
2. Click on the button corresponding to your language and then
select the M-Print software in the window that opens subse
quently.
3. The installation routine starts automatically; follow the
instructions on the screen.
4. Close all windows.
Enable code
1. Start M-Print by selecting Start > Programs > M-Print.
2. The following window appears:
10
All manuals and user guides at all-guides.com
2100
4000
3. Click on Registration in order to enter the enable code. This can
be found on the cover to the CD-ROM. Please note the use of
upper- and lower-case letters.
5. Basic settings in the printer driver
The Weidmüller MultiCard is made from polyamide. One property of
this is to influence the dimensions of the MultiCard by 1% in the
case of large fluctuations in the ambient conditions (temperature
and humidity).
To check the settings, switch off the fusing unit. After
checking the dimensions, you can wash the markings off the
MultiCard with water and reuse it.
Start your M-Print: Start > Programm > M-Print or click to your link
M-Print. Go to File > Plot > Settings, there you could see the set-
tings of the zero points, which you can change. These figures repre-
sent typical values and must be adapted to suit your MultiCards and
your system with the help of the margin and scaling functions in M-
Print.
Choose the Device Printer EPSON Stylus COLOR 680/685.
Click to Accept and close the other window with cancel.
Connect the Weidmüller PrintJet with your PC
Setting of the zero points
If you change the zero points, it is changed for all MultiCards. If you
need a configuration for one MultiCard, please use the configuration
editor with the help in the M-Print.
You see the MultiCard frame with 5 MultiCards.
With a double click of one Card a window will open. In this window
you could choose a MulitCard. Confirm you chose with Ok.
Carry out the fine calibration with the DEK 5.5 MultiCard supplied.
Select the DEK 5.5 from the menu window, label this with the letter
X (see example below) and print out the markers.
10