Installation; Faucet Assembly/Installation - Glacier bay QL068 Manuel De L'utilisateur

Installation

FAUCET ASSEMBLY/INSTALLATION

1 . Connect the faucet head to the hose .
2 . Feed the hose through the neck of the faucet if not pre-assembled .
3 . From underneath, slide the rubber gasket and retaining nut over the end
of the faucet shank, tighten the nut by hand until it is snug .
4 . Connect the hose end to the outlet .
5 . Connect the water supply lines (not supplied) to the faucet .
6 . Install the weight a couple of inches from the bottom of the hose on the
side closest to the faucet head . There should be no slack in the hose .
All manuals and user guides at all-guides.com
6
Faucet head
Faucet shank
Base plate
Rubber gasket
Retaining nut
Weight
Water Supply Lines
Outlet
Sink
Hose end