Controls And Components; Delivery Content; Before First Time Use - OK. OPJ 4321 Mode D'emploi

CONTROLS AND COMPONENTS

A. Pusher
B. Lid with feeding chute
C. Locking groove
D. Stainless steel sieve with blade
E. Sieve holder
F. Spout
G. Base with motor

DELIVERY CONTENT

1 x Juicer
1 x User manual
1 x Warranty card

BEFORE FIRST TIME USE

• Remove the product and accessories carefully from the original packaging. It is recommended to keep
the original packaging for storage. If you wish to dispose of the original packaging, please observe
applicable legal provisions. Should you have any questions regarding proper disposal, contact your
local waste management center.
• Check for completeness and transport damage. In case of damages or incompleteness please contact
your dealer.
• After unpacking, please refer to chapter Cleaning and care.
Before using the first time, all removable parts should be cleaned.
1
Note: Wash all removable parts with water, mixed with a little detergent and then rinse and dry
thoroughly.
Alternative the parts A, B, D, E, H and M can also be cleaned in the dishwasher.
Disassemble the device as follows:
a) Put down the safety bar.
b) Remove the pomace container.
c) Remove the lid with the feeding chute.
d) Pull off the sieve holder upwards together with the sieve.
Note: The sieve holder is fixed relatively tight. Pull from all sides, especially at the side of the
spout.
e) Remove the sieve from the sieve holder.
ASSEMBLY
WARNING! Never connect the power plug into an electrical outlet before the appliance is fully
assembled.
2 Place the base on a dry, flat, and steady surface. Press the base firmly on the surface so that the
suction feet get a good grip.
3 Place the sieve holder on the base. Make sure sieve holder and spout fit in place correctly.
Attaching the pulp container: Insert its upper part under the receptacle lip. Push the lower part
4
firmly into the pulp container holder.
Insert the stainless steel sieve inside the receptacle, matching its bottom with the base shaft.
5
6 Lock the sieve in place: Press the sieve edge downward until a click is heard.
Place the lid on the juicer.
7
Lock the bar: Lift up the locking bar until it fits the locking grooves on both sides of the lid.
8
IM_OPJ4321_181029_V07_HR.indb 11
All manuals and user guides at all-guides.com
H. Juice container
I. Locking bar
J. Power cord with power plug
K. Vacuum cup feet
L. On/off switch (O, 1, 2, P)
M. Pomace container
N. Container holder
11
EN
29/10/18 10:43 am