RCA 24V510 Manuel page 13

DVD
VCR
DVD and
VCR
VOL
MUTE GO BACK
buttons
CLEAR
OK OK
PRESETS
CC
GUIDE
1
4
7
INPUT
REVERSE
PLAY
RECORD STOP
REVERSE
AGAIN ZOOM
and PLAY
SPEED
SEARCH
buttons
You'll use these buttons when
programming the remote.
Using Direct Entry
1. Turn on the component to be programmed.
2. Look up the brand and code number(s) for the component on the code list in this section.
3. Press and hold the component button you want to program on the remote.
4. Enter the code from the remote control code list on the following pages. If the indicator flashes, you
have either entered an invalid code or the button isn't programmable.
5. Release the component button.
6. Point the remote at the component. Press ON•OFF to see if the component responds to the
command. If it doesn't, try pressing the component button and then ON•OFF again.
• If you get no response, repeat these steps using the next code listed for your brand, until the
component responds to the remote commands.
• If you try all the codes for your component brand and none work, try the automatic code search
method. If automatic code search doesn't find the code, the remote is not compatible with your
component.
Chapter 2
ON OFF
ON•OFF
TV
button
CH
MENU
SKIP
INFO
2 3
5 6
8 9
ANTENNA
0
FORWARD
PAUSE
OPEN CLOSE
STOP
button
Using the Remote Control
Using Automatic Code Search
The following instructions can be used to program the
remote to operate each of your components. If you want to
stop the automatic code search without programming any of
your components, press CLEAR until the indicator on the
remote turns off.
1. Turn on the component you want to operate (VCR or DVD
player)
2. Press and hold the component button you want to
program (VCR or DVD). While holding the component
button, press and hold ON•OFF until the indicator on the
remote turns on, then release both buttons.
3. Point the remote at the component. Press and release
PLAY, then wait 5 seconds or until the indicator on the
remote stops flashing.
At this point the remote is searching for the correct code
to program. If, after 5 seconds, the component you want
to operate does not turn off, press PLAY again to tell the
remote to search the next set of codes.
Continue pressing PLAY until the component turns off or
you have searched through all of the codes. There are 20
total sets of codes. If the component does not turn off
after pressing PLAY 20 times, then the remote can't be
programmed to operate that component.
If the component you want to operate does turn off:
1. Press and release REVERSE, then wait 2 seconds. Repeat
this step until the device turns back ON.
2. To finish, press and hold STOP until the indicator on the
remote turns off.
11