Beper 40.967N Manuel D'instructions page 8

Facial steamer Use instructions
Description Fig.A
1. Facial mask
2. Water tank/steam bowl
3. Base
4. On / off and steam regulation button
5. Non-slip feet
6. Cord supply
7. Tray for essential oil
8. Lid of the tray for essential oil
Use instructions
Do not use the sauna as a substitute for medical treatment.
Fill the tank with water, using the appropriate measuring cup.
Be careful not to overfill the tank; the water must not escape.
Insert the face mask.
Insert the power cord plug into the socket.
Turn the knob clockwise until the red control lamp lights up. Turn the knob initially to position "2" to accelerate
the heating. After some minutes the steam starts to rise, then return the knob to position "1" to reduce the
steam flow.
Place your face as close as possible to the edge of the mask.
Keep the position for about 1 to 2 minutes, depending on your personal resistance to heat.
If you experience a feeling of discomfort or excessive heat, move your face to a greater distance from the
mask.
Do not cover with blankets or anything else; even more when the face is on the facial mask.
It is possible to repeat the operation according to your needs.
It is also possible to use the product with essential oils by carefully following the instructions below:
Do not use essential oils as a substitute for water, but only in addition to a sufficient quantity of water.
The tray for essential oils allows you to use oils and other essences as part of an aromatic treatment. In this
way, oils and other essences, mixed with steam, release better their effectiveness. However, do not use saline
solutions.
Can be used only oils and essences whose use is intended for steam masks and which have been approved
for this purpose by the relative manufacturer.
Open the lid of the tray for essential oils, pressing lightly on the two tabs placed on the sides of the cover and
pulling slightly upwards. Pour a few drops of oil on a cotton ball. Insert the cotton ball into the tray, then close
the lid.
Warning: do not pour essences directly into the water tank, as the appliance may be damaged and
the warranty will automatically expire.
Cleaning and care
Before cleaning the sauna, switch it off and remove the plug from the electrical socket.
Let the sauna cool down.
Remove excess water and dry thoroughly the facial mask that can be washed with water.
Clean the base with a slightly damp cloth and dry well with a dry cloth.
Do not immerse in water.
Do not use abrasive products or other detergents, they could damage the sauna.
Store the facial sauna in a dry place keep away from children.
Technical data
Power: 100W
Power supply: 220-240V ~ 50/60Hz
For any improvement reasons, Beper reserves the right to modify or improve the product without any
notice.
8