Parameter Setting - aquaforte IH30 Instructions D'installation

5
Repeat above steps to set other 3 timers
6
Hold 3 seconds to save setting
7
or Check 4 timers to make sure there is no invalid setting
Note: Overlap setting of time will be considered as invalid, the pump will only run based on the
previous valid setting.
During timer setting, if you want to return to the previous setting, hold both
for 3 seconds.

5.8 Parameter Setting

Restore factory setting
Check the software
version
Enter parameter setting
as below
Parameter
Description
Address
1
2
3
Self-priming/
4 Backwash
capacity
Control mode of
5
Analog Input
8
Under off mode, hold both
Under off mode, hold both
Under off mode, hold both
current address does no need to be adjusted, hold both
to next address
Default Setting
PIN3 100%
PIN2 80%
PIN1 40%
100%
30~100%, by 5% increments
30~100%, by 5% increments
30~100%, by 5% increments
80~100%, by 5% increments
0
for 3 seconds
for 3 seconds
for 3 seconds; If
Setting Range
0: current control
1: Voltage control