F.F. Group DH 15-30 PRO Notice Originale page 7

DH 15-30 PRO
tion. Loosen the knurled nut 4, turn the auxiliary
handle 3 around the machine axis to the desired
position and tighten the knurled nut 4 again.
CHANGING THE TOOL
By installing and removing accessories, please
make sure that the tool is OFF, and the cord should
not be plugged in. Pull out the stop pin 1 and swivel
it to turn the flange towards the direction of mo-
tor housing. Insert accessory into the tool holder
through the dust shield and then swivel the stop
pin back until it locks the accessory into place.
Inserting the tool
Clean and lightly grease the shank end of the tool.
Whirligig the stop pin to 180°and insert the tool in
twisting manner into the tool holder until it locks
into place. Swivel the stop pin back. Then check
the latching by pulling the tool.
Removing the tool
Whirligig the stop pin to 180° and remove the
tool.
OPERATION
SWITCHING ON AND OFF
To start the machine, push the On/Off switch 5 to
the "I" position.
To switch off the machine, push the On/Off switch
5 to the "0" position.
WORKING ADVICE
While working, hold the power tool with both hands
by the handle 8. The handle 8 can move upward and
downward around its axis by approx. 30 mm. This has
a damping effect against vibrations.
For the highest possible impact damping, work only
with moderate pressure.
MAINTENANCE
Regular inspection and cleaning reduces the neces-
sity for maintenance operations and will keep your
tool in good working condition. The motor must be
correctly ventilated during tool operation. For this
reason avoid blocking the air inlets.
The power tool is grease-lubricated. Grease chang-
ing is required only within the scope of maintenance
or repair through an authorized after-sales service
agent.
ENVIRONMENTAL PROTECTION
Recycle raw materials instead of disposing
as waste. Machine, accessories and pack-
aging should be sorted for environment -
friendly recycling. The plastic components
are labeled for categorized recycling.
EXPLANATION OF SYMBOLS
Double insulation
For indoor use only. Do not expose
to rain.
• Wear eye protection.
• Damage to lungs if an effective dust
mask is not worn.
• Damage to hearing if effective hear-
ing protection is not worn.
Wear protective gloves
To reduce the risk of injury, the user
must read and understand this manu-
al before using this product.
Important!
Conforms to relevant safety stan-
dards
GUARANTEE
This product is warranted in accordance with the le-
gal/country specific regulations, effective from the
date of purchase by the first user. Damage attribut-
able to normal wear and tear, overload or improper
handling will be excluded from the guarantee. In
case of a claim, please send the machine, completely
assembled, to your dealer or the service Centre for
electric power tools.
DECLARATION OF CONFORMITY
ƒ We declare under our sole responsibility that this
product is in conformity with the following stan-
dards or standardized documents: EN 55014-1, EN
55014-2, EN 61000-3-2, EN 61000-3-3, EN 60745-1,
EN 60745-2-6, in accordance with the provisions of
the directives 2014/30/EU, 2006/42/EC.
ƒ Technical file at:
FF GROUP TOOL INDUSTRIES
19300, Aspropyrgos-Greece
Loudovikos Tsirigiotis
Operations & Engineering
FF GROUP TOOL INDUSTRIES, 19300
Aspropyrgos-Greece. 25/9/2018
English | 7
www.ffgroup-tools.com