Prem-I-Air EH0287 Mode D'emploi page 5

When used in an office environment, this product must be safety-tested yearly by
a qualified electrician (PAT Tested) in order to comply with the Electricity at Work
Regulations.
We recommend that it is PAT tested regularly when used in a domestic
environment.
GENERAL SAFETY REQUIREMENTS
Domestic wiring must be tested periodically by a qualified electrician at least
once every 10 years or at every change of occupancy. For office and retail
premises, and buildings such as village halls, the wiring must be inspected at
least once every 5 years.
It is recommended that all building be fitted with smoke alarms (it is mandatory
for new buildings).
Before cleaning, turn the appliance off, and disconnect from the mains supply.
The appliance may then be cleaned using a damp cloth with a drop of washing-
up liquid to remove any dust or dirt from the case. Do no use stronger detergents
or solvents as these may damage the plastic.
Using a dry 1" (25 mm) paint-brush, remove any dust from the grilles.
This appliance is filled with a precise quantity of special oil. Repairs requiring the
opening of the oil container are only to be carried out by the manufacturer or his
service agent who should be contacted if there is an oil leak.
If the mains lead is damaged, it must be replaced by the manufacturer or and
authorised service centre. If the mains plug needs to be replaced, proceed as
follows:
PAT TESTING
MAINTENANCE
Connect the brown wire to the terminal
•
labelled "L".
Connect the blue wire to the terminal
•
labelled "N".
Connect the green/yellow wire to the
•
terminal labelled with the earth symbol
or "E".
Make
•
positioned correctly (over the outer
sheath of the cable) and it fully
tightened.
5
sure that the cord-grip is